Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-639004.png)
14. Remove the special tools from the crankshaft pulley.
15. Using the special tool, remove the crankshaft front seal.
^
Remove the outer section of the seal.
^
Repeat the process to remove the inner section of seal.
16. Check the crankshaft damper pulley and locking ring for damage.
Installation
1. Clean all the crankshaft pulley mating faces.
2. Using the special tools, install the crankshaft front seal.
^
Lubricate the seal with clean engine oil.
^
Use the discarded crankshaft bolt with the service tool.
3. Install the crankshaft pulley.
^
Lubricate the seal with clean engine oil.
4. Install the crankshaft pulley locking ring.
CAUTION: The screw thread in the crankshaft pulley must be cleaned out before installing a new crankshaft pulley bolt.
5. Install, but do not tighten, the new crankshaft pulley bolt.
CAUTION: Under no circumstances should the crankshaft setting peg, 303-645, be used in the following operations, to restrain the
