Range Rover (LM) V8-4.4L (2009)
-
Disconnect the electrical connector.
Installation
All vehicles
1. Install the recirculation blend door actuator.
-
Connect the electrical connector.
Left-hand drive vehicles
2. Install the CJB.
-
Install the screws.
3. Connect the CJB electrical connectors.
Right-hand drive vehicles
4. Install the driver side closing trim panel.
-
Connect the electrical connectors.
-
Attach the vehicle diagnostic socket.
5. Secure the driver side closing trim panel.
-
Install the screws.
-
Install the clip.
6. Install the driver side floor console extension.
-
Secure the clips.
-
Install the screw.
7. Install the lower glove compartment.
8. Disconnect the battery ground cable.