Range Rover (LM) V8-4.4L (2009)
4. Remove the LH auxiliary blend door actuator.
-
Remove the 2 screws.
Installation
1. Install the LH blend door actuator.
-
Install the 2 screws.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.
2. Install the LH blend door actuator link rod.
-
Connect the electrical connector.
3. Install the floor console stowage compartment.
4. Connect the battery ground cable.
Defrost Vent/Register Blend Door Actuator
Defrost Vent/Register Blend Door Actuator
Removal
Left-hand drive vehicles
NOTE: LHD illustration shown, RHD is similar.
1. Remove the driver side floor console extension.
-
Remove the screw.
-
Release the 2 clips.
NOTE: LHD illustration shown, RHD is similar.
2. Release the driver side closing trim panel.
-
Remove the 4 screws.
-
Remove the clip.