Range Rover (LM) V8-4.4L (2009)
Right-hand drive vehicles
NOTE: Left-hand shown, right-hand similar.
6. Remove the driver side floor console extension.
-
Remove the screw.
-
Release the 2 clips.
7. Release the driver side closing trim panel.
-
Remove the 4 screws.
-
Remove the clip.
8. Remove the driver side closing trim panel.
-
Disconnect the 2 electrical connectors.
-
Release the vehicle diagnostic socket.
All vehicles
9. Remove the recirculation blend door actuator.
-
Disconnect the electrical connector.
Installation
All vehicles
1. Install the recirculation blend door actuator.
-
Connect the electrical connector.
Left-hand drive vehicles
2. Install the CJB.
-
Install the screws.
3. Connect the CJB electrical connectors.
Right-hand drive vehicles