Range Rover (LM) V8-4.4L (2009)
5. Release the driver side closing trim panel.
-
Remove the 4 screws.
-
Remove the clip.
6. Remove the driver side closing trim panel.
-
Disconnect the 2 electrical connectors.
-
Release the vehicle diagnostic socket.
All vehicles
7. Remove the recirculation blend door actuator.
-
Disconnect the electrical connector.
Installation
All vehicles
1. Install the recirculation blend door actuator.
-
Connect the electrical connector.
Left-hand drive vehicles
2. Install the driver side closing trim panel.
-
Attach the vehicle diagnostic socket.
-
Connect the electrical connectors.
3. Secure the driver side closing trim panel.
-
Install the screws.
-
Install the clip.
4. Install the driver side floor console extension.
-
Secure the clips.
-
Install the screw.
Right-hand drive vehicles
5. Install the lower glove compartment.
6. Connect the battery ground cable.