Range Rover (LM) V8-4.4L (2009)
Passenger Side Temperature Blend Door Actuator
Passenger Side Temperature Blend Door Actuator
Removal
1. Remove the glove compartment.
2. Remove the passenger side closing trim panel.
-
Release the clip.
-
Remove the 2 screws.
-
Disconnect the electrical connector.
3. Remove the passenger side footwell duct.
-
Remove the clip.
4. Remove the passenger side footwell duct elbow.
-
Remove the 2 Torx screws.
5. Remove the temperature blend door actuator.
-
Disconnect the electrical connector.
-
Remove the 2 screws.
Installation
1. Install the temperature blend door actuator.
-
Tighten the screws.
-
Connect the electrical connector.
2. Install the passenger side footwell duct elbow.
-
Tighten the screws.
3. Install the passenger side footwell duct.