Range Rover (LM) V8-4.4L (2009)
Installation
All vehicles
1. Install the defrost vent blend door actuator.
^
Connect the electrical connector.
Left-hand drive vehicles
2. Install the driver side closing trim panel.
^
Connect the electrical connectors.
^
Attach the vehicle diagnostic socket.
3. Secure the driver side closing trim panel.
^
Install the screws.
^
Install the clip.
4. Install the driver side floor console extension.
^
Secure the clips.
^
Install the screw.
Right-hand drive vehicles
5. Install the passenger side closing trim panel.
^
Connect the footwell lamp electrical connector.
^
Install the screws.
6. Install the passenger side floor console extension.
^
Install the screw.
^
Secure the clips.
Driver Side Recirculation Blend Door Actuator
Driver Side Recirculation Blend Door Actuator
Removal
Left-hand drive vehicles
1. Make the air bag supplemental restraint system (SRS) safe.
2. Disconnect the battery ground cable.
3. Remove the lower glove compartment.
4. Disconnect the central junction box (CJB) 8 electrical connectors.