Range Rover (LM) V8-4.4L (2009)
1. Install the recirculation blend door actuator.
^
Connect the electrical connector.
Left-hand drive vehicles
2. Install the CJB.
^
Install the screws.
3. Connect the CJB electrical connectors.
Right-hand drive vehicles
4. Install the driver side closing trim panel.
^
Connect the electrical connectors.
^
Attach the vehicle diagnostic socket.
5. Secure the driver side closing trim panel.
^
Install the screws.
^
Install the clip.
6. Install the driver side floor console extension.
^
Secure the clips.
^
Install the screw.
7. Install the lower glove compartment.
8. Disconnect the battery ground cable.
Driver Side Temperature Blend Door Actuator
Driver Side Temperature Blend Door Actuator
Service Repair No - 80.10.37
Removal
1. Remove the instrument panel driver side reinforcement.
2. Remove the driver side footwell duct.
^
Remove the 2 Torx screws.
3. Remove the temperature blend door actuator.
^
Disconnect the electrical connector.
^
Remove the 2 screws.
Installation
1. Install the temperature blend door actuator.