Range Rover (LM) V8-4.4L (2009)
Installation
All vehicles
1. Install the recirculation blend door actuator.
^
Connect the electrical connector.
Left-hand drive vehicles
2. Install the driver side closing trim panel.
^
Attach the vehicle diagnostic socket.
^
Connect the electrical connectors.
3. Secure the driver side closing trim panel.
^
Install the screws.
^
Install the clip.
4. Install the driver side floor console extension.
^
Secure the clips.
^
Install the screw.
Right-hand drive vehicles
5. Install the lower glove compartment.
6. Connect the battery ground cable.
Auxiliary Temperature Blend Door Actuator
Auxiliary Temperature Blend Door Actuator
Service Repair No - 82.26.34
Removal
1. Disconnect the battery ground cable.
2. Remove the floor console stowage compartment.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.
3. Remove the LH blend door actuator link rod.
^
Disconnect the electrical connector.
4. Remove the LH auxiliary blend door actuator.
^
Remove the 2 screws.