Range Rover (LM) V8-4.4L (2009)
Installation
1. Install the LH blend door actuator.
^
Install the 2 screws.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.
2. Install the LH blend door actuator link rod.
^
Connect the electrical connector.
3. Install the floor console stowage compartment.
4. Connect the battery ground cable.
Auxiliary Footwell Vent/Duct Blend Door Actuator
Auxiliary Footwell Vent/Duct Blend Door Actuator
Removal
1. Disconnect the battery ground cable.
2. Remove the floor console rear trim panel.
3. Remove the footwell vent/duct blend door actuator link rod.
^
Disconnect the electrical connector.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.
4. Remove the footwell vent/duct blend door actuator.
^
Remove the 2 screws.
Installation
1. Install the footwell vent/duct blend door actuator.
^
Install the 2 screws.
2. Install the footwell vent/duct blend door actuator link rod.
^
Connect the electrical connector.
CAUTION: Make sure damage does not occur to the auxiliary temperature blend door actuator link rod.