Range Rover (LM) V8-4.4L (2009)
3. Install the evaporator temperature sensor to the heater and evaporator core housing.
4. Connect the floor duct actuator motor electrical connector.
5. Install the right-hand footwell duct.
-
Install the screws.
-
Install the clip.
6. Install the thermostatic expansion valve cover.
-
Install the screws.
-
Secure the wiring harness to the tangs.
7. Install the heater core, inlet and outlet pipes.
-
Clean the component mating faces.
-
Lubricate and install the new O-rings.
-
Tighten the screws to 10 Nm (7 lb.ft).
8. Install the gasket to the heater core inlet and outlet pipes.
9. Install the left-hand air intake duct.
-
Install the screws.
10. Install the left-hand footwell duct.
-
Install the screws.
11. Reposition the heater and evaporator core housing for access.
12. Install the heater and evaporator core housing.
13. Connect the battery ground cable.