Range Rover (LM) V8-4.4L (2009)
Power Steering Pressure Control Valve: Service and Repair
Power Steering Control Valve Actuator
Service Repair No - 57.10.05
Removal
1. Disconnect the battery ground cable.
2. Raise the vehicle on the lift.
3. Remove the front wheel and tire.
CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug
open connections to prevent contamination.
NOTE:
Note the fitted position.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
4. Remove the power steering control valve actuator.
^
Disconnect the electrical connector.
^
Position a container to collect the fluid spillage.
^
Remove and discard the 2 Torx screws.
^
Remove and discard the 2 O-ring seals.
^
Remove and discard the filter.
Installation
CAUTION: Make sure the working surfaces are thoroughly clean to avoid contamination of the sensitive hydraulic components.
1. Clean the component mating faces.
2. Install a new filter to the steering gear.
3. Install new seals to the actuator.
NOTE:
Align to the position noted on removal.
4. Install the actuator.
^
Tighten the new Torx screws, evenly and progressively, to 3 Nm (2.2 ft. lbs.).
^
Connect the electrical connector.
5. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
6. Connect the battery ground cable.
7. Refill and bleed the power steering.