Range Rover (LM) V8-4.4L (2009)
CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
6. Using the special tool, release the LH rear lower arm from the wheel knuckle.
^
Remove the nut.
7. Remove the LH rear lower arm.
^
Remove and discard the bolt.
8. Remove the LH rear lower arm ball joint.
^
Remove and discard the 2 bolts.
Installation
CAUTION: Make sure that new bolts are installed.
1. Install the LH rear lower arm ball joint.
^
Tighten the bolts to 60 Nm (44 ft. lbs.).
WARNING: Make sure that a new bolt is installed.
CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
2. Install the LH rear lower arm.
^
Tighten the nut and bolt to 165 Nm (121 ft. lbs.). plus a further 90 degrees.