Range Rover (LM) V8-4.4L (2009)
/v8-4.4l/Page-1734003.png)
NOTE:
Models with standard brakes shown, models with high performance brakes similar.
1. Install the air suspension spring.
^
Clean the component mating faces.
^
Install a new gasket.
^
Install the air line but do not tighten the union fully at this stage.
^
Tighten the nuts to 56 Nm (41 ft. lbs.).
2. Tighten the air line union to 3.5 Nm (2.6 ft. lbs.).
3. Connect the hub to the air suspension spring.
^
Clean the component mating faces.
^
Fit bolts and tighten nuts to 250 Nm (184 ft. lbs.).
CAUTION: The washer is hardened and must be fitted in the correct position.
NOTE:
Use an additional wrench to prevent the component from rotating.
4. Connect the stabilizer link.
^
Install the special washer.
^
Tighten the nut to 100 Nm (74 ft. lbs.).
5. Secure ABS sensor lead and brake line.
^
Secure into the 3 clips.
6. LH side: Secure the brake pad wear sensor lead.
^
Secure in the clip.
7. Vehicles with high performance brakes: Install a new damper.
^
Clean the component mating faces.
^
Apply a 3 mm bead of high strength retainer STC 50554 to the thread.
^
Tighten to 20 Nm (15 ft. lbs.).
^
Install the cap.
CAUTION: The air springs must be fully pressurized before the weight of the vehicle is applied to them.
8. Using the Land Rover approved diagnostic system, pressurize the air suspension.
9. Install the road wheel.
