Range Rover (LM) V8-4.4L (2009)
Installation
CAUTION: Make sure the new Voss connector is installed and fully tightened with the alignment plug installed.
NOTE:
New air suspension components are supplied with new Voss connectors tightened to the correct torque. Do not install new voss connectors if a
new component is being installed.
1. Install new Voss connectors to the air suspension rear solenoid valve block.
^
Tighten to 2.5 Nm (1.7 ft. lbs.).
NOTE:
Make sure the valve block does not become detached during connection of the air lines.
2. Install the air suspension rear solenoid valve block.
^
Secure the 3 valve block rubber insulators.
^
Connect the air lines into the Voss connector.
^
Pull on each air line to make sure it is fully installed into the Voss connector.
^
Connect the electrical connector.
3. Install the RH fender splash shield.
^
Install the plastic nuts.
^
Install the screws.
^
Install the clips.
^
Install the fender seal.
4. Connect the battery ground cable.
5. Using T4, pressurize the air suspension.