Range Rover Sport (LS) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1943006.png)
NOTE: Note the routing of the parking brake emergency release cable.
1. Install the parking brake actuator and cable assembly.
^
Install the 2 nuts.
^
Connect the electrical connector.
NOTE: Remove and discard the blanking caps.
2. RH side rear: Connect the brake line.
^
Clean the component mating faces.
^
Secure the clip.
^
Tighten the brake line union to 16 Nm (12 ft. lbs.).
CAUTION: Make sure the parking brake emergency release cable to body seal is installed correctly
3. Locate and secure the parking brake emergency release cable.
4. Install the fuel tank heat shield.
^
Tighten the bolts to 6 Nm (4 ft. lbs.).
^
Tighten the nuts to 3 Nm (2 ft. lbs.).
5. Secure the fuel tank breather line bracket.
^
Install the plastic insert.
6. Locate and secure the RH parking brake cable.
^
Tighten the bolts to 22 Nm (16 ft. lbs.).
^
Secure the parking brake cable to the 2 pipe clips.
^
Secure the cable grommet to the integrated body frame bracket.
7. Locate and secure the LH parking brake cable.
^
Tighten the bolts to 22 Nm (16 ft. lbs.). Secure the wiring harness.
^
Secure the cable grommet to the integrated body frame bracket.
NOTE: Make sure that the brake cable circlip is positioned as shown.
8. Connect the parking brake cables to the wheel hubs.
^
Connect the cable to the brake shoe lever.
^
Locate the cable to the backplate.
^
Tighten the nut to 8 Nm (6 ft. lbs.).
CAUTION: Make sure that the component is clean, free of foreign material and lubncant.
9. Install the LH rear brake disc.
^
Tighten the Torx screw to 35 Nm (26 ft. lbs.).
10. Secure the LH rear brake caliper.
^
Remove and discard the tie strap.
^
Tighten the bolts to 115 Nm (85 ft. lbs.).
CAUTION: Make sure that the component is clean, free of foreign material and lubricant.
11. Install the RH rear brake disc.
^
Tighten the Torx screw to 35 Nm (26 ft. lbs.)
