ES 330 V6-3.3L (3MZ-FE) (2004)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
ABS Actuator
REPLACEMENT
1. DRAIN BRAKE FLUID
NOTICE: Wash off the brake fluid immediately if it comes into contact with a painted surface.
2. REMOVE BRAKE ACTUATOR WITH BRACKET
a. Using SST, disconnect the 6 brake lines from the actuator.
SST 09023-00100
b. Use tags or make a memo to identify the place to reconnect.
c. Disconnect the brake actuator connector.
d. Remove the 3 nuts and brake actuator with bracket.
3. REMOVE BRAKE ACTUATOR ASSEMBLY
a. Remove the 2 nuts and brake actuator from the bracket.
b. Remove the 2 holders and 3 cushions from the brake actuator.
4. INSTALL BRAKE ACTUATOR ASSEMBLY
a. Install the 3 cushions and 2 holders to the brake actuator.
b. Install the brake actuator to the bracket with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
5. INSTALL BRAKE ACTUATOR WITH BRACKET
a. Install the brake actuator with the 3 nuts.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
b. Connect the brake actuator connector.