ES 330 V6-3.3L (3MZ-FE) (2004)
/Page-881002.png)
NOTICE:
^
If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
^
Do not scratch the contacting surface of axle hub and speed sensor.
7. INSTALL SKID CONTROL SENSOR
a. Clean the contacting surface of the axle hub and a new skid control sensor.
NOTICE: Make sure the sensor rotor is clean.
b. Place the speed sensor on the axle hub so that the connector is positioned, as shown in the illustration.
c. Using SST and a press, install the skid control sensor to the axle hub.
NOTICE:
^
Do not tap the skid control sensor with a hammer directly.
^
Check that the skid control sensor detection part is clean.
^
Press in the skid control sensor straight and slowly.
SST 09830-36010, 09950-60010 (09951-00650), 09950-70010 (09951-07100)
8. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
a. Install the rear axle hub & bearing assembly with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59 ft. lbs.)
9. INSTALL REAR DISC
10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY, LH
11. CONNECT SKID CONTROL SENSOR WIRE
12. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
13. INSPECT TIRE
14. MEASURE VEHICLE HEIGHT
15. INSPECT SIDE SLIP
16. INSPECT CAMBER
17. INSPECT TOE-IN
18. ADJUST CAMBER AND TOE-IN
