ES 350 V6-3.5L (2GR-FE) (2007)
f.
Using a screwdriver, disengage the 3 claws.
HINT: Tape the screwdriver tip before use.
g. Remove the rear door inside locking cable assembly.
INSTALLATION
1. INSTALL REAR DOOR LOCK ASSEMBLY
NOTE:
-
When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
-
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
-
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion to the connection. This
may result in a malfunction of the rear door lock assembly.
a. Install the rear door inside locking cable assembly.