GS 350 RWD V6-3.5L (2GR-FSE) (2007)
3.
Remove the engine compartment side cover RH by removing 2 clips.
4.
Remove the engine compartment side cover LH by removing the 3 clips.
5.
Remove the V-bank cover sub-assembly.
A.
Hold the front of the V-bank cover and raise it to disengage the 3 clips on the front of the cover.
B.
Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.
NOTE:
Attempting to disengage both the rear and front clips at the same time may cause the cover to break.
6.
Discharge the fuel system pressure.
FUEL SYSTEM CAUTIONS:
^
Do NOT smoke or work near an open flame when working on the fuel system.
^
Keep gasoline away from rubber or leather parts.
^
Do NOT allow fuel to spray when removing the pipe between the high pressure side fuel pump and the fuel injector. The fuel in the pipe is
highly pressurized.
^
Wear safety goggles while working with fuel system under pressure.
^
Do NOT disconnect any part of the fuel system until you have discharged the fuel system pressure.