GS 350 RWD V6-3.5L (2GR-FSE) (2007)
a. Using SST, install the sensor to the front exhaust pipe.
b. Pass the sensor connector through the floor panel and install the grommet.
SST 09224-00010
Torque:
without SST 44 N.m (449 kgf.cm, 32 ft.lbf)
with SST 40 N.m (408 kgf.cm, 30 ft.lbf)
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
-
Make sure SST and the wrench are connected in a straight line.
c. Connect the sensor connector.
2. INSTALL FRONT FLOOR COVER LH (for 4WD)
a. Install the cover with the 2 clips and 4 nuts.
3. INSTALL FRONT SEAT ASSEMBLY LH (for 4WD)
a. Install the front seat LH.
4. INSTALL CONSOLE BOX (for 4WD)
5. INSTALL CONSOLE BOX REGISTER ASSEMBLY (for 4WD)
6. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2 2WD)
a. Using SST, install the sensor to the front exhaust pipe.
SST 09224-00010