GS 350 RWD V6-3.5L (2GR-FSE) (2007)
/Page-790004.png)
Torque:
without SST 44 N.m (449 kgf.cm, 32 ft.lbf)
with SST 40 N.m (408 kgf.cm, 30 ft.lbf)
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
-
Make sure SST and wrench are connected in a straight line.
b. Pass the sensor connector through the floor panel and install the grommet.
c. Connect the sensor connector.
7. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
a. Using SST, install the sensor to the front exhaust pipe.
SST 09224-00010
Torque:
without SST 44 N.m (449 kgf.cm, 32 ft.lbf)
with SST 40 N.m (408 kgf.cm, 30 ft.lbf)
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
-
Make sure SST and wrench are connected in a straight line.
b. Pass the sensor connector through the floor panel and install the grommet.
