GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Secondary Injector Control Module: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE NO. 1 AIR CLEANER INLET
a. Remove the bolt and No. 1 air cleaner inlet.
4. REMOVE NO. 1 ENGINE COVER
a. Remove the clip, 2 cap nuts and cover.
5. REMOVE INJECTOR DRIVER
a. Disconnect the 4 injector driver connectors.
1. Move the lock lever in the direction indicated by the arrow to release the connector lock.
Disconnect the 3 connectors with wire harness locks and the connector from the injector driver.