GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
2. REMOVE NO.2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
a. Using a screwdriver, detach the 2 clips and 2 claws.
HINT: Tape the screwdriver tip before use.
b. Remove the speaker panel.
3. REMOVE FRONT NO.2 SPEAKER ASSEMBLY
a. Remove the 2 bolts.
b. Disconnect the speaker connector and remove the speaker.
NOTE: Do not touch the cone part of the speaker.
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
1. INSTALL FRONT NO.2 SPEAKER ASSEMBLY