Toyota GS 450h V6-35L Air Bag System Component Service and Repair
3. REMOVE NO. 2 STEERING WHEEL COVER LOWER
a. Using a screwdriver, remove the No. 2 steering wheel cover lower.
HINT: Tape the screwdriver tip before use.
4. REMOVE STEERING PAD
a. Using a T30 "TORX" socket wrench, loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
b. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
NOTE: When removing the steering pad, do not pull the airbag wire harness.
c. Disconnect the horn connector.
d. Disconnect the 2 connectors and remove the steering pad.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALLATION
1. INSTALL STEERING PAD