GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
a. Support the steering pad with one hand as shown in the illustration.
b. Connect the 2 connectors to the steering pad.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
c. Connect the horn connector.
d. Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel
assembly.
e. Using a T30 "TORX" socket wrench, tighten the 2 "TORX" screws.
Torque: 8.8 N.m (90 kgf.cm, 78 in.lbf)
2. INSTALL NO. 3 STEERING WHEEL COVER LOWER
3. INSTALL NO. 2 STEERING WHEEL COVER LOWER
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INSPECT STEERING PAD
a. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad
with a new one: Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
b. Make sure that the horn sounds.
HINT: If the horn does not sound, inspect the horn system.
6. PERFORM INITIALIZATION
a. Perform initialization.