GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
(b) Using SST, disconnect the toe control link from the rear axle carrier.
SST 09628-00011
NOTICE:
^
Pay careful attention not to damage the rear axle carrier because it is made of aluminum and may be damaged easily.
^
Do not damage the ball joint dust cover.
^
Make sure that SST is securely set to the rear axle carrier spacer.
^
If the rear axle carrier spacer has come off, replace the rear axle carrier with a new one.
^
Make sure that the string of SST is securely tied to the vehicle.
20. REMOVE REAR AXLE ASSEMBLY
(a)
Using a plastic-faced hammer, remove the drive shaft from the rear axle carrier.
(b) Remove the rear axle.
NOTICE:
^
Be careful not to damage the boot.
^
Use a wire or an equivalent to keep the rear drive shaft from hanging down.
21. REMOVE REAR NO. 2 WHEEL BEARING DUST DEFLECTOR
(a)
Using a screwdriver, remove the bearing dust deflector from the rear axle carrier.
22. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
(a)
Hold the axle hub and bearing in a vise between aluminum plates.
NOTICE:
Do not overtighten the vise.
(b) Remove the 4 bolts and axle hub and bearing from the rear axle carrier.
INSTALLATION