GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
(e)
Fully tighten the adjusting nut by hand.
INSTALLATION
1. INSTALL REAR PROPELLER SHAFT ASSEMBLY
(a)
Apply grease to the flexible coupling centering bushings.
Grease:
Molybdenum disulfide lithium base NLGI No. 2
(b) Align the matchmarks on the transmission companion flange and flexible coupling.
(c)
Install and tighten the 6 bolts, washers and nuts.
Torque: 79 N*m (805 kgf*cm, 58 ft.*lbf)
HINT:
The bolts should be installed from the propeller shaft side.
NOTICE:
Be careful not to damage the flexible coupling centering bush.
(d) Align the matchmarks on the differential companion flange and flexible coupling.
(e)
Install the 6 bolts, washers and nuts.
Torque: 79 N*m (805 kgf*cm, 58 ft.*lbf)
HINT:
The bolts should be installed from the propeller shaft side.
NOTICE:
Be careful not to damage the flexible coupling centering bush.