GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
(f)
Temporarily install the 2 center support bearing dampers with the adjusting washers.
HINT:
Use the adjusting washers which were removed.
2. FULLY TIGHTEN CENTER NO. 1 SUPPORT BEARING ASSEMBLY
(a)
Adjust the dimension between the edge surface of the center support bearing and the edge surface of the cushion to 11.5 to 13.5 mm (0.452
to 0.531 in.) as shown in illustration.
(b) Check that the center line of the bracket is at right angles to the shaft axial direction.
(c)
Tighten the 2 bolts.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)