HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
_hybrid/Page-1694003.png)
(d) Remove the clamp from the front shock absorber assembly.
(e) Remove the bolt and front speed sensor from the steering knuckle.
NOTICE:
*
Prevent foreign matter from attaching to the front speed sensor tip.
*
Clean the front speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: INSTALLATION
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.
1. INSTALL FRONT SPEED SENSOR
(a) Install the front speed sensor to the steering knuckle with the bolt.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
*
Prevent foreign matter from attaching to the front speed sensor tip.
*
Firmly insert the front speed sensor body into the knuckle before tightening the bolt.
*
After installing the front speed sensor to the knuckle, make sure that there is no clearance between the front speed sensor stay and
knuckle. Also make sure that no foreign matter is stuck between the parts.
(b) Install the clamp to the front shock absorber assembly.
(c) Temporarily install the front brake flexible hose.
Text in Illustration
(d) Install the front brake flexible hose and No. 1 sensor clamp together to the front shock absorber with the bolt.
Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)
NOTICE:
