HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
*
Do not twist the wire harness for the front speed sensor when installing the front speed sensor.
*
A bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front speed sensor is positioned over the
front brake flexible hose.
(e) Install the No. 2 sensor clamp to the body with the bolt.
Text in Illustration
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
(f) Connect the front speed sensor connector.
(g) Install the 2 front speed sensor wire harness clamps to the body.
2. INSTALL FRONT FENDER LINER
(a) Install the front fender liner with the 9 clips, 10 screws, bolt and 3 new grommets.
3. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Starting and
Charging/Battery/Service and Repair/Installation.
5. INSTALL LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Installation
6. CHECK FOR SPEED SENSOR SIGNAL
See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure