HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(d) Install the connector cover assembly with the 2 bolts.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
CAUTION:
Wear insulated gloves.
NOTICE:
*
Make sure that the interlock is fully engaged.
*
Do not allow any foreign objects or water to enter the inverter with converter assembly.
9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
(a) Remove the bolt and disconnect the discharge hose sub-assembly from the electric inverter compressor.
(b) Remove the O-ring from the discharge hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
10. DISCONNECT SUCTION HOSE SUB-ASSEMBLY
(a) Remove the bolt and disconnect the suction hose sub-assembly from the electric inverter compressor.
(b) Remove the O-ring from the suction hose sub-assembly.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
11. REMOVE ELECTRIC INVERTER COMPRESSOR
(a) Release the green-colored lock and disconnect the connector (A) as shown in the illustration.