HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Text in Illustration
(3) Using SST, apply the specified torque to the adjusting tube in the following order and check that the matchmarks are still aligned: 1)
extend direction, 2) contract direction. (Step D)
Text in Illustration
SST : 09612-24014
09617-24011
without SST - Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)
with SST - Torque : 17 Nm (174 kgf-cm, 13 ft-lbf)
NOTICE:
*
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
*
This torque value is effective when SST is parallel to the torque wrench.
(4) Hold the adjusting tube in place and, using SST, apply the specified torque to the nut on the ball joint side in the following order and check
that the matchmarks are still aligned: 1) loosing direction, 2) tightening direction. (Step E)
Text in Illustration
SST : 09612-24014