HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
NOTICE:
Confirm that the driver side knee airbag assembly is installed securely without any excessive gaps and is not protruding outward.
2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Lower Instrument Panel/Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
(a) Connect the cable to the negative (-) battery terminal and close the front luggage compartment trim cover.
(b) for Power Tilt and Power Telescopic Steering Column:
(1) Reset the auto away/return function setting to the previous condition by changing the customize parameter See: Steering and
Suspension/Steering/Steering Column/Testing and Inspection/Programming and Relearning.
4. INSTALL LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Installation
5. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Check / Clear.
6. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
Components
SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: COMPONENTS
Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing See: Service Precautions.
NOTICE:
w/ Navigation System for HDD: