HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
HINT
Perform the same procedure as the LH side.
18. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH See: Control Arm/Service and Repair/Rear Lower Arm/Removal
19. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
20. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY LH See: Rear Knuckle/Service and Repair/Removal
21. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
22. REMOVE REAR STABILIZER LINK ASSEMBLY LH See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
23. REMOVE REAR STABILIZER LINK ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
24. REMOVE REAR SUSPENSION MEMBER BRACE LH See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
25. REMOVE REAR SUSPENSION MEMBER BRACE RH
HINT
Perform the same procedure as the LH side.
26. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
(a) Support the rear No. 2 suspension arm assembly LH using a jack and wooden block.
Text in Illustration
(b) Loosen the bolt (A).
NOTICE:
*
Since a stopper nut is used, turn the bolt.
*
Do not remove the bolt.
(c) Remove the bolt (B) and nut, and then slowly lower the rear No. 2 suspension arm assembly LH, and remove the rear coil spring LH.
NOTICE:
Since a stopper nut is used, turn the bolt.
(d) Remove the bolt, nut and rear No. 2 suspension arm assembly LH from the rear suspension member sub-assembly.