HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
3. SEPARATE FRONT SPEED SENSOR LH
(a) Remove bolt B, bolt C and the clamp, and separate the front speed sensor LH and front flexible hose LH from the shock absorber and the
steering knuckle.
NOTICE:
*
Prevent foreign matter from adhering to the front speed sensor LH.
*
Be careful not to damage the front speed sensor LH.
Text in Illustration
4. SEPARATE FRONT SPEED SENSOR RH
HINT
Use the same procedure as for the LH side.
5. SEPARATE FRONT FLEXIBLE HOSE LH
(a) Remove bolt A and separate the flexible hose LH from the steering knuckle.
6. SEPARATE FRONT FLEXIBLE HOSE RH
HINT
Use the same procedure as for the LH side.
7. SEPARATE TIE ROD END SUB-ASSEMBLY LH See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Removal and
Replacement/Removal
8. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT
Use the same procedure as for the LH side.
9. REMOVE FRONT AXLE HUB NUT LH
(a) Using SST and a hammer, release the staked part of the front axle hub nut LH.
SST : 09930-00010
NOTICE:
Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
(b) While applying the brakes, remove the front axle hub nut LH.
10. REMOVE FRONT AXLE HUB NUT RH
HINT
Use the same procedure as for the LH side.