HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
(a) Remove the nut and separate the front stabilizer link assembly LH.
Text in Illustration
NOTICE:
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT
Use the same procedure as for the LH side.
13. SEPARATE FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY LH
(a) Remove the bolt and 2 nuts, and separate the front No. 1 lower suspension arm sub-assembly LH from the lower ball joint LH.
14. SEPARATE FRONT NO. 1 LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT
Use the same procedure as for the LH side.
15. SEPARATE FRONT DRIVE SHAFT ASSEMBLY LH
(a) Put matchmarks on the front drive shaft assembly LH and the front axle hub sub-assembly LH.
Text in Illustration
(b) Using a plastic hammer, separate the front drive shaft assembly LH from the front axle assembly LH.
NOTICE:
Be careful not to damage the front axle outboard joint boot and front speed sensor rotor.