HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
16. SEPARATE FRONT DRIVE SHAFT ASSEMBLY RH
HINT
Use the same procedure as for the LH side.
17. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
(a) Using SST, remove the front drive shaft assembly LH.
SST : 09520-01010
SST : 09520-24010
09520-32040
NOTICE:
*
Do not damage the hybrid transaxle case oil seal.
*
Do not damage the front axle inboard joint boot.
*
Do not drop the front drive shaft assembly LH.
18. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
(a) Remove the 2 bolts and pull out the front drive shaft assembly RH together with the drive shaft bearing case sub-assembly.
(b) Remove the front drive shaft assembly RH from the hybrid transaxle.
NOTICE:
*
Do not damage the hybrid transaxle case oil seal.
*
Do not damage the front axle inboard joint boot.
*
Do not drop the front drive shaft assembly RH.
19. REMOVE FRONT DRIVE SHAFT LH HOLE SNAP RING (for LH Side)
(a) Using a screwdriver, remove the front drive shaft LH hole snap ring.
Installation
DRIVE SHAFT / PROPELLER SHAFT: FRONT DRIVE SHAFT ASSEMBLY: INSTALLATION
1. INSTALL FRONT DRIVE SHAFT LH HOLE SNAP RING (for LH Side)
(a) Install a new front drive shaft LH hole snap ring to the front drive inboard joint assembly LH.
HINT