IS 250C V6-2.5L (4GR-FSE) (2011)
/Page-2102014.png)
HINT
*
If the roof panel movement is not within the specified range, turn the adjustment screw on the roof panel strength sub-assembly to
adjust the amount of movement. Loosen the lock screw before turning the adjustment screw.
*
When tightening the adjustment screw of the roof panel strength sub-assembly, the distance (A) between the front header and the
front slide roof panel sub-assembly will become larger, and when loosening it, the distance (A) will become smaller.
*
After the adjustment, tighten the lock screw.
(o) Using a 5 mm hexagon wrench, turn the sliding roof drive gear sub-assembly counterclockwise to release the lock of the rear slide roof panel
sub-assembly.
NOTICE:
*
Insert the hexagon wrench all the way in and turn it with both hands.
*
Do not apply excessive force after the drive gear stops turning.
HINT
The locks will release when the wrench is turned approximately 360 degrees.
(p) Fully close the upper back window frame sub-assembly manually.
NOTICE:
*
Perform this operation using 2 persons.
*
Synchronize the movement of the left and right sides of the upper back window frame sub-assembly when moving it.
(q) Using a 5 mm hexagon wrench, turn the sliding roof drive gear sub-assembly clockwise to engage the lock of the rear slide roof panel
sub-assembly.
NOTICE:
*
Insert the hexagon wrench all the way in and turn it with both hands.
*
Do not apply excessive force after the drive gear stops turning.
HINT
The locks will engage when the wrench is turned approximately 360 degrees.
(r) Apply tape as shown in the illustration.
