IS 250C V6-2.5L (4GR-FSE) (2011)
HINT
*
The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor needs to be replaced, replace
the front axle hub sub-assembly.
*
If the sensor rotor needs to be replaced, replace it together with the front axle hub sub-assembly.
2. INSPECT FRONT AXLE HUB BEARING LOOSENESS See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Front Axle
Hub
3. INSPECT FRONT AXLE HUB RUNOUT See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Front Axle Hub
4. INSTALL FRONT DISC (for Opposed Type Caliper) See: Disc Brake System/Service and Repair/Removal and Replacement/Front Brake (for
Opposed Type Caliper)/Installation
5. INSTALL FRONT DISC (for Floating Type Caliper) See: Disc Brake System/Service and Repair/Removal and Replacement/Front Brake (for
Floating Type Caliper)/Installation
6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Fastener/Service and Repair/Front Axle
Hub Bolt/Replacement
7. CONNECT FRONT SPEED SENSOR WIRE
(a) Connect the front speed sensor wire to the front speed sensor.
NOTICE:
Do not twist the front speed sensor wire.
8. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INSPECT SPEED SENSOR SIGNAL
HINT
See: Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure