IS 250C V6-2.5L (4GR-FSE) (2011)
Wheel Speed Sensor: Service and Repair
Rear Speed Sensor
Components
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: COMPONENTS
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE REAR WHEEL
4. REMOVE REAR SPEED SENSOR WIRE
(a) Using a screwdriver, disconnect the rear speed sensor wire.
5. REMOVE REAR SPEED SENSOR
(a) Remove the bolt and rear speed sensor.