IS 250C V6-2.5L (4GR-FSE) (2011)
8. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes.
9. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
Components
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: COMPONENTS
Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: REMOVAL
1. REMOVE NO. 1 CONSOLE BOX DUCT
HINT
Refer to the procedure up to Remove No. 1 Console Box Duct See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal.
2. DISCONNECT NO. 2 INSTRUMENT PANEL WIRE
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Slide the slider to release the lock, and then disconnect the connector.