IS 250C V6-2.5L (4GR-FSE) (2011)
Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)
(d) Temporarily install the control shaft lever.
(e) Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
Text in Illustration
(f) Remove the transmission control shaft lever.
(g) Align the neutral alignment mark with the switch groove, and tighten the adjusting bolt.
Text in Illustration
Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)
(h) Using a screwdriver, bend the tabs of the lock washer.