IS 250C V6-2.5L (4GR-FSE) (2011)
(a) Install the No. 1 body mounting bracket sub-assembly LH with the 3 bolts.
Torque : 52 Nm (530 kgf-cm, 38 ft-lbf)
13. INSTALL NO. 1 BODY MOUNTING BRACKET SUB-ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
14. INSTALL FRONT FLOOR COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
15. INSTALL FRONT FLOOR COVER RH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
16. STABILIZE SUSPENSION See: Suspension Strut / Shock Absorber/Service and Repair/Front Shock Absorber/Installation
17. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING See: Suspension Strut / Shock Absorber/Service and Repair/Front
Shock Absorber/Installation
18. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY
(a) Fully tighten the bolt on the front of the front lower suspension arm assembly.
Torque : 135 Nm (1377 kgf-cm, 100 ft-lbf)
(b) Fully tighten the nut of the No. 2 lower arm bracket assembly.
Torque : 113 Nm (1152 kgf-cm, 83 ft-lbf)
19. INSTALL ENGINE UNDER COVER
20. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
21. CHECK FOR SPEED SENSOR SIGNAL
HINT
Check for speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Test Mode Procedure.
22. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT