IS 250C V6-2.5L (4GR-FSE) (2011)
Rear Knuckle: Service and Repair
Removal
AXLE AND DIFFERENTIAL: REAR AXLE CARRIER: REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. REMOVE REAR AXLE ASSEMBLY
HINT
Refer to the procedure up to Remove Rear Axle Assembly See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal.
2. REMOVE REAR NO. 2 WHEEL BEARING DUST DEFLECTOR See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
3. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
4. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY
(a) Hold the rear axle assembly between aluminium plates in a vise.
NOTICE:
Do not overtighten the vise.
(b) Remove the 2 nuts, parking brake anchor block sub-assembly, cable support bracket and parking brake plate sub-assembly.