IS 250C V6-2.5L (4GR-FSE) (2011)
Rear Knuckle: Service and Repair
Installation
AXLE AND DIFFERENTIAL: REAR AXLE CARRIER: INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
(a) Hold the rear axle assembly between aluminium plates in a vise.
NOTICE:
Do not overtighten the vise.
(b) Install the parking brake anchor block sub-assembly, cable support bracket and parking brake plate sub-assembly with the 2 nuts.
Torque : 76 Nm (770 kgf-cm, 56 ft-lbf)
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
3. INSTALL REAR NO. 2 WHEEL BEARING DUST DEFLECTOR See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation
4. INSTALL REAR AXLE ASSEMBLY
HINT
Refer to the procedure from Install Rear Axle Assembly See: Wheel Hub/Service and Repair/Rear Axle Hub/Installation.