IS 250C V6-2.5L (4GR-FSE) (2011)
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. REMOVE REAR WHEEL
2. REMOVE REAR NO. 2 FLOOR HOUSING SHIELD
3. REMOVE REAR WHEEL HOUSE LINER
4. REMOVE CAP
(a) Disengage the 4 claws, and then remove the cap.
5. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR
(a) Remove the 2 nuts and No. 2 differential support protector.
6. REMOVE REAR SUSPENSION MEMBER BRACE
(a) Remove the 2 bolts and rear suspension member brace.
7. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY
(a) Support the rear axle assembly with a jack using a wooden block.
Text in Illustration
(b) Loosen the nut (A).