LS 460 V8-4.6L (1UR-FSE) (2007)
/Page-1675007.png)
(c)
Remove the nut, rear suspension attachment sub-assembly, and rear No. 2 suspension toe adjust plate. Then remove the rear No. 2 suspension
arm assembly.
17. DISCONNECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
(a)
Remove the nut from the rear No. 1 suspension arm.
(b) Install 2 spacers (SST spacer B) onto the rear No. 1 suspension arm so that there is a space of approximately 1 mm between the arm and
spacers.
SST 09960-20010 (09961-02060)
NOTICE:
^
Make sure to install the spacers (SST spacer B) as the steering knuckle spacer may shift.
^
As SST may become damaged, make sure the space between the arm and spacers is not 1 mm or less.
(c)
Using SST, disconnect the rear No. 1 suspension arm from the axle carrier.
SST 09960-20010 (09961-02010)
NOTICE:
^
Do not damage the ball joint dust cover.
^
As the dust cover may be damaged, adjust SST with the center nut so that the body and crow are parallel.
^
Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
18. DISCONNECT TOE CONTROL LINK SUB-ASSEMBLY LH
(a)
Remove the nut on the rear axle carrier side.
(b) Install 2 spacers (SST spacer B) onto the toe control link so that there is a space of approximately 1 mm between the arm and spacers.
SST 09960-20010 (09961-02060)
NOTICE:
^
Make sure to install the spacers (SST spacer B) as the steering knuckle spacer may shift.
^
As SST may become damaged, make sure the space between the arm and spacers is not 1 mm or less.
