LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(a) Install the No. 5 brake actuator bracket to the body with the bolt.
Torque: 11 Nm (112 kgf-cm, 8 ft-lbf)
10. INSTALL BRAKE ACTUATOR AND BRAKE ACCUMULATOR PUMP ASSEMBLY
(a) Install the brake actuator and brake accumulator pump to the body with the bolt (labeled A) and 2 nuts (labeled B).
-
Do not damage the brake tubes.
-
When installing the brake actuator and brake accumulator pump to the vehicle, do not hold the connector, harness, hose or tube parts.
-
Do not drop the brake actuator and brake accumulator pump. Do not use parts that have been dropped.
HINT: First insert the bracket bottom's longer stud bolt (vehicle outer side, labeled C) into the body.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(b) Connect the front fender liner rear side.
(c) Connect the No. 1 brake actuator hose to the body with the clamp.
(d) Connect the brake actuator connector.
-
Before connecting the vehicle wire harnesses, make sure that the connector faces are free of foreign matter.
-
Make sure that the connector is locked securely.
11. CONNECT BRAKE TUBE