LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(2) Place the front seat outer belt on the ground and cover it with a tire (with wheel).
NOTE:
Set up the front seat outer belt as shown in the illustration.
(3) Move SST at least 10 m (33 ft.) away from the wheel.
NOTE:
Take care not to damage SST wire harness.
(d) Activate the seat belt pretensioner.
(1) Connect SST's red clip to the battery's positive (+) terminal and the black clip to the battery's negative (-) terminal.
(2) Check that no one is within 10 m (33 ft.) of the wheel.
(3) Press SST activation switch to activate the seat belt pretensioner.
HINT: The seat belt pretensioner operates at the same time SST activation switch's LED illuminates.
(e) Dispose of the front seat outer belt (with the seat belt pretensioner).
CAUTION:
-
Do not touch the front seat outer belt for at least 30 minutes after the seat belt pretensioner has been activated. It is very hot.
-
Use gloves and safety glasses when handling a front seat outer belt whose pretensioner has been activated.
-
Always wash your hands with water after completing the disposal.
-
Do not apply water to a front seat outer belt that has an activated pretensioner.
(1) Remove the tire (with wheel) and SST.
(2) Place the front seat outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.
Removal
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL
REMOVAL
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY See: Body and Frame/Seats/Service and Repair/Front Seat Assembly/Removal
2. REMOVE FRONT SEAT ASSEMBLY See: Body and Frame/Seats/Service and Repair/Front Seat Assembly/Removal
3. REMOVE COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL